Guide Brisbane

Asbestos on older homes: budget the assessment first

If your Brisbane home was built or renovated before 1990 it may contain asbestos, so get it assessed before you finalise plans and prices, and know the 10 square metre rule, licence classes and clearance requirements.

Build in Brisbane Guides 8 October 2026
Older timber house half-hidden by palms and garden, Queensland

This guide is for Brisbane homeowners with a house built or renovated before 1990, which covers most Queenslanders, post-war fibro and weatherboard homes, and plenty of 1970s and 80s brick houses in suburbs like Carindale and Chermside. If you’re planning a renovation, extension or knockdown, find out what asbestos you have and where it is before you lock in a design or a budget.

Asbestos rarely stops a project. Finding it halfway through, with the builder stood down and a removalist booked at short notice, is what blows out time and money.

Why 1990 is the date to remember

The Queensland Government’s asbestos website says that if your house was built before 1990, there’s a good chance it contains asbestos. Brisbane City Council puts it this way:

  • houses built or renovated before the mid-1980s are more than likely to contain asbestos materials
  • houses built or renovated between the mid-1980s and 1990 are likely to contain them
  • houses built after the 1990s are highly unlikely to.

Asbestos cement sheeting was commonly used from the 1940s to the late 1980s. Australia banned asbestos in December 2003, but that ban didn’t remove what was already in buildings.

Note the word “renovated”. A 1910 Queenslander can have a 1970s bathroom, an enclosed verandah or a room built in underneath. The age of each part of the house matters, not just the original build date.

Where it hides in Brisbane houses

The Queensland Government and Council list these common locations:

  • Wet areas. Wall and ceiling sheeting in kitchens, bathrooms and laundries
  • Dry areas. Wall sheeting in bedrooms and living rooms
  • Outside. Eaves and soffits, gables, wall cladding, imitation brick cladding, roof sheeting and capping (such as Super 6), gutters and downpipes
  • Floors. Vinyl floor tiles, and the felt backing under some vinyl and linoleum sheet flooring
  • Surfaces. Textured paint and plaster patching compounds
  • Services. Water, drainage and flue pipes, and the backing board inside an electricity meter box
  • Around the yard. Fences, carports and sheds
  • Other. Felt or hessian carpet underlay, and some old heaters, stoves and hot water systems.

You can’t reliably tell by looking. The Queensland Government’s advice is to assume a material contains asbestos until a sample has been tested by an accredited laboratory.

Friable vs non-friable: the difference that sets the price

Non-friable (bonded)Friable
What it isAsbestos bound into cement or resinLoosely bound material that can crumble to powder by hand pressure when dry
Typical examplesFibro sheeting, roof sheets, eaves, vinyl tilesFelt backing under vinyl sheet flooring, some old heater insulation and pipe lagging, low density asbestos fibre board
RiskLow if in good condition and left aloneFibres become airborne very easily
Who can remove itUp to 10 m²: no licence needed, but safe work rules apply. Over 10 m²: Class A or Class B licensed business (or a certified homeowner)Only a Class A licensed removalist

The rules in Queensland

The 10 square metre rule

As a homeowner or owner-builder, you can remove 10 square metres or less of non-friable asbestos without a certificate, as long as you follow safe work procedures. To remove more than 10 square metres yourself, you need a certificate obtained under arrangements approved by Queensland Health. Otherwise, use a licensed removalist.

As a guide, the Queensland Government says 10 square metres is about four sheets of asbestos cement wall sheeting, or usually only one wall of an average bathroom. It goes faster than people think.

Tradespeople and businesses working on your home have their own rules. Removing more than 10 square metres of non-friable asbestos needs a Class B or Class A licence from Workplace Health and Safety Queensland. Friable asbestos always needs a Class A licence.

Never use power saws, drills, sanders, angle grinders or high-pressure water blasters on asbestos materials.

Notification and clearance

  • Licensed removalists must notify Workplace Health and Safety Queensland at least five days before starting licensed asbestos removal work. Build that into your program.
  • After licensed removal, a clearance inspection is required. For Class A work it must be done by an independent licensed asbestos assessor. For Class B work, an independent competent person can do it.
  • On domestic premises, the licensed removalist is responsible for making sure the clearance inspection happens.
  • A clearance certificate can only be issued if the area is free of visible asbestos contamination and, if air monitoring was done, fibre levels are below 0.01 fibres/mL.

Before demolition

Queensland’s work health and safety rules require asbestos to be removed before demolition starts, so far as is reasonably practicable. If you’re knocking down all or part of the house, asbestos removal is a stage of the job, not an afterthought.

Disposal

Council’s resource recovery centres don’t accept asbestos or materials containing asbestos. Council says dumping asbestos in bins, public places or its resource recovery centres is illegal and fines can exceed $50,000. Certified contractors with tracking certificates can apply to dispose of asbestos at Brisbane’s landfill, which isn’t open to the public.

Get an asbestos assessment before the designer finalises plans and before the builder prices the job. Knowing exactly which walls, floors and eaves contain asbestos lets everyone quote the same scope, and it stops the most common mid-job variation on older Brisbane homes.

Why budget the assessment first

An assessment usually means a consultant inspecting the house, taking samples of suspect materials and sending them to a laboratory, then giving you a report on what was found, where and in what condition. The Queensland Government suggests contacting the National Association of Testing Authorities (NATA) to find accredited labs, and notes there will be fees.

We haven’t quoted prices because they vary too much from house to house. These are the things that drive the cost of assessment and removal:

  • how many materials need sampling, and how many lab tests
  • access: roof spaces, under floors, high eaves and tight crawl spaces take longer
  • friable vs non-friable, and therefore Class A vs Class B work
  • the total area to be removed
  • air monitoring, if needed, and the clearance inspection
  • transport and disposal at an approved facility
  • making good afterwards: new sheeting, linings and flooring
  • program delays, including the five-day notice period.

Ask for removal quotes that list each of these items separately so you can compare like with like.

Step-by-step for a renovation

  1. Work out the age of each part of the house, including later additions.
  2. Book an asbestos assessment that covers every area your project will touch.
  3. Give the report to your designer and builder before final plans and pricing.
  4. Decide what to remove, and what can stay sealed and undisturbed.
  5. Get itemised quotes from licensed removalists for the right class of licence.
  6. Check their licence on the WorkSafe Queensland register.
  7. Allow at least five days’ notice in the program before removal starts.
  8. Get the clearance certificate before other trades go back in.
  9. Keep the assessment, removal paperwork and clearance certificate with your house records.

Questions to ask an asbestos removalist

  • What’s your licence number, and is it Class A or Class B?
  • Does the business name on your quote match the licence?
  • Who will do the clearance inspection, and are they independent?
  • Is air monitoring included?
  • Where will the waste go, and is disposal included in the price?
  • What making good, if any, is included?

Common mistakes

  • Testing only the obvious fibro. Vinyl backing, meter boards and textured coatings get missed.
  • Pulling up old vinyl sheet flooring yourself. The backing may be friable and Class A only.
  • Underestimating 10 square metres. One bathroom wall can use it up.
  • Pressure cleaning a fibro house or roof before painting. Never use high-pressure water on asbestos.
  • Taking it to the tip. Brisbane’s resource recovery centres don’t accept it.
  • Not telling the neighbours. The Queensland Government recommends explaining your safety precautions to them.

Who to talk to

Through the Build in Brisbane directory you can find:

  • Asbestos assessors and consultants for inspection, sampling and clearance
  • Licensed asbestos removalists (Class A or Class B)
  • Demolition contractors for partial or full knockdowns
  • Builders who can program removal into the job
  • Electricians for meter box replacements where the backing board contains asbestos.

Sources

This guide is general information only, not legal or safety advice. If you suspect asbestos, don’t disturb it. Check current requirements with WorkSafe Queensland, the Queensland Government asbestos website or Brisbane City Council, and use licensed professionals.

One enquiry, one business

Find a licensed trade for this job

Browse local trades with their QBCC licence on the listing. Your enquiry goes to the one business you pick.