Guide Brisbane

Check the character overlay before you design

Before you pay for plans on a Queenslander or pre-war house, look up your Traditional building character, pre-1911 and heritage overlays on City Plan online so you know what you can demolish, raise, build under and extend.

Build in Brisbane Guides 8 October 2026
Green timber house raised on stumps in a tropical garden, Queensland

This guide is for Brisbane homeowners with an older house: a Queenslander in Paddington, a worker’s cottage in New Farm, an interwar bungalow in Bulimba, Wynnum or Indooroopilly. If you’re thinking about raising, extending, building in underneath or knocking something down, check which character rules apply to your block before you pay anyone to draw plans.

It takes about twenty minutes on Council’s website. It tells you what you can remove, how high you can lift the house, where an extension can sensibly go, and whether you’ll need a planning approval from Brisbane City Council as well as a building approval from a certifier.

Heritage and character are not the same thing

People use the two words interchangeably, but Brisbane City Plan 2014 treats them differently.

  • Heritage means a specific place that has been assessed as culturally significant. Local heritage places sit in the Heritage overlay in City Plan. State heritage places are on the Queensland Heritage Register and are dealt with by the Queensland Government.
  • Character is about how a building’s style contributes to the look of a street. Council says character properties are mainly buildings built before the end of 1946, with extra protection for buildings built before 1911. A character house doesn’t need to be heritage listed to be protected.

So “it’s not heritage listed” doesn’t mean “there are no rules”. Plenty of ordinary timber houses across the inner and middle suburbs are covered by character controls without being heritage places.

The overlays most house owners run into

City Plan identifies three types of character property, plus the Heritage overlay. Here’s how they compare for a typical house.

OverlayWhat it protectsWhat it usually means for you
Traditional building character (TBC)Pre-1947 streetscapes in parts of older suburbs, based on building character, materials, layout and setbacksDemolition of a house built in 1946 or earlier needs planning approval unless an exception applies. External extensions generally need planning approval. New houses must fit the character of the street.
Pre-1911 buildingHouses built before 1911The house is to be kept. Extensions shouldn’t alter the original parts. Demolition needs planning approval.
Commercial character buildingOlder shops and commercial buildingsThe building is to be kept and extensions must complement its style. Less common for homeowners.
Heritage (local or State)Places with assessed heritage significanceMost changes need a development application, unless the work is covered by an exemption certificate.

Your zone matters too. City Plan has a Character residential zone, and Council notes that if your property is in a neighbourhood plan area, extra criteria apply and you may need planning approval. Check all three: overlays, zone and neighbourhood plan.

How to look up your property on City Plan online

  1. Go to Council’s City Plan online page and open the interactive map (“View map”).
  2. Search your street address or lot and plan number. Your property is highlighted on the map.
  3. Use the map layers to switch on the Heritage, Traditional building character, Commercial character building and Pre-1911 building overlays. Use the legend to read the colours.
  4. Note your zone and whether a neighbourhood plan applies.
  5. Download the property report. It’s a short summary of the City Plan requirements that apply to your site. Keep a copy for your designer.
  6. Click “View section” next to any overlay to read the actual code.
  7. If you’re unsure when your house was built, City Plan online includes historic aerial basemaps from 1946, and Council has a practice note on determining a building’s construction date.

Council’s Planning Information Officers can give general advice on 07 3403 8888 if the map doesn’t make sense to you.

Demolition: the rule that catches people out

In the TBC overlay, City Plan controls the demolition, removal or repositioning of a building if any part of it was substantially built in 1946 or earlier. Council’s own FAQ is blunt: if your home was built during or before 1946, you’ll need an approval to do minor demolition to it, unless the work fits one of the listed exceptions.

“Demolition” here includes partial demolition. Taking out a front wall, removing an original verandah or swapping old windows for a different style can all count.

Council lists some minor demolition in the TBC and pre-1911 overlays that doesn’t need planning approval, including:

  • demolishing an internal wall or feature
  • demolishing a stair
  • demolishing a post-1946 addition, extension or free-standing outbuilding
  • removing a post-1946 alteration to reveal the original design, or reconstructing with the original form and materials
  • replacing windows, doors, balustrades, window hoods and fretwork from a pre-1947 house with new features of the same style and appearance.

These exceptions sit in table 5.3.4.1 (Prescribed accepted development) in City Plan and Council warns they’re subject to change, so check the current version before you rely on them.

Outside the TBC overlay, demolition also needs planning approval for local heritage places, Queensland Heritage Register places and anything in the pre-1911 overlay.

Raising and building in under a Queenslander

Lifting a high-set timber house and building in underneath is the classic Brisbane renovation. Here’s what the rules say.

Raising

Council lists raising a house in the TBC overlay as work that may not need planning approval, where the new height doesn’t exceed 9.5 metres. The City Plan code says the 9.5 metre figure applies unless a neighbourhood plan sets a different height. The intent behind the rule is that a raised pre-1947 house should still fit the scale and proportion of the other old houses in the street.

Go over that height and you’ll need a development application. If your block is flood affected, the minimum floor level may push you higher than you expected. Read our flood guide before settling on a height.

Building in underneath

Council also lists enclosing under an existing building as minor work that may not need planning approval in the TBC overlay. Conditions apply, such as setbacks and any other overlays on your site, so confirm the detail in table 5.3.4.1 with your designer or planner.

You still need building approval

Whatever the planning position, Council says you’ll need building approval from a licensed building certifier before starting extensions, raising or renovations. Planning approval and building approval are two separate things. See our guide to what a certifier does.

Extensions and renovations

For properties in the TBC overlay, Council says:

  • you’ll generally need planning approval for external extensions
  • some extensions and renovations to a house built in or before 1946 need planning approval
  • work that involves demolishing part of a pre-1947 house may be assessed against both the TBC demolition code and the TBC design code.

Purely internal renovations are unlikely to need planning approval.

Council describes the TBC overlay as being about the visual qualities of the street. That’s why designers working on character houses tend to keep the street-facing form intact and put the bigger changes behind it. Council’s Traditional Housing: Alterations and Extensions Design Guide is worth reading before your first design meeting. It explains the house styles and design approaches Council considers respectful of the streetscape.

Check the overlay, zone and neighbourhood plan first, then brief your designer. A concept drawn without knowing the controls is the most common way Brisbane owners pay for plans twice.

When to bring in a town planner

You don’t need a town planner for every job. A short consult is money well spent if:

  • your property has the TBC, pre-1911 or Heritage overlay and you want external changes
  • you want to demolish anything that isn’t clearly on the exceptions list
  • you want to raise above 9.5 metres or a neighbourhood plan height
  • your block is a corner lot or a small lot, or several overlays stack up
  • you want to remove the whole house and rebuild.

For demolition applications, Council recommends getting specialist consultant advice before you lodge and says you’ll need specialist reports to support the application. Council works out development application fees with a points system that varies by project, so ask for a fee quote rather than guessing.

Step-by-step: before you brief a designer

  1. Look up your property on City Plan online and download the property report.
  2. Note every overlay, your zone and any neighbourhood plan.
  3. Work out roughly when the house was built (1946 aerial, Council’s practice note, old records).
  4. Pull a FloodWise Property Report at the same time, since flood levels affect raising.
  5. Read the relevant overlay code sections and Council’s design guide.
  6. Write down what you want: raise, build under, rear extension, new deck, pool.
  7. Book a short meeting with a town planner or an experienced designer to sense-check the brief.
  8. Only then commission concept drawings.

Common mistakes

  • Assuming no heritage listing means no rules. Character controls are separate.
  • Replacing original features in a different style. Like-for-like replacement is an exception. A modern window in an old frame opening may not be.
  • Guessing the construction date. Many rules hinge on 1946 or 1911. Keep any research, as Council says it can support an application.
  • Treating a raise as just a building job. Height, flood levels and the overlay all interact.
  • Relying on what a neighbour did. Their approval, timing and site may have been different, and City Plan changes over time.

Who to talk to

Through the Build in Brisbane directory you can find the trades that usually help with character homes:

  • Town planners for overlay advice, demolition and development applications
  • Building designers and drafting services for concepts and approval drawings
  • Building certifiers for building approval and inspections
  • Builders and house raising specialists with Queenslander experience
  • Surveyors for levels and boundaries, especially before a raise.

For heritage places, Council suggests heritage architects or consultants and tradespeople experienced in heritage conservation.

Sources

This guide is general information only, not legal or planning advice. City Plan is amended regularly. Check the current rules for your property with Brisbane City Council or a qualified town planner before you design or build.

One enquiry, one business

Find a licensed trade for this job

Browse local trades with their QBCC licence on the listing. Your enquiry goes to the one business you pick.